Turn the power OFF, wait 5-seconds and turn back ON.If all wire connections look ok, the incline motor will need to be adjusted. It could also just mean the incline motor needs to be adjusted back into range. This can happen when there is a bad wire harness connection or a damaged wire harness. The E7 code means the potentiometer value the console is reading from the lift motor is out of range. Watch our one-minute tutorial on the easiest way to lubricate your treadmill belt.Īn E6 or E7 error code is an incline error code. Doing so will prevent friction from damaging the newly installed components or other components in the machine. If needing to replace either of these components, it will likely be necessary to replace the running belt as well. Without lubrication, continued use can cause damage to the motor and/or the motor control board which may require replacing of these components. If there is no belt movement, or you notice a burning smell coming from the motor area, this may be an indication that the motor or motor control board has become damaged. If the running belt stops after 6 seconds of starting the treadmill, this may indicate that either the speed sensor needs adjusting/replacing or the main wire harness is damaged. In this instance you may need to replace the running belt as continued use can lead to damage of other components such as the motor and the motor control board. When this occurs, the running belt can no longer absorb lubrication. This is a term used that describes the pores on the underside of the running belt closing due to excess friction. When lubricating be sure to use a 100% silicone non-aerosol treadmill lubricant, applying 1-oz.Īfter lubricating the running belt, if you still continue to have problems or it returns after just a few weeks, the running belt may have become glazed. The lubrication frequency will vary depending on the model, please refer to the lubrication instructions in the owner's manual. It is important to maintain a proper lubrication schedule for your treadmill. The motor control board will shut down due to the motor pulling too much current, triggering a safety shut down. If the running belt moves for several minutes and then produces the E1 error, this is most commonly a result of the running belt needing lubrication. An E1 code just means that the console is not getting a reading from the reed switch (Speed Sensor). It is important to know when the E1 occurs and what was being done when it occurred.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |